c23b33f531
The Bananapi M3 has an RTL8211E PHY connected to the EMAC using RGMII. The PHY is powered by DCDC1 through SW @ 3.3V. The board is designed to use 3.3V with RGMII, instead of the standard reduced voltage of 2.5V we see everywhere. DLDO3, which provides the I/O voltages, is raised to match. This patch enables the EMAC and Realtek PHY drivers in the defconfig. The device tree file already has the EMAC enabled. Signed-off-by: Chen-Yu Tsai <wens@csie.org> Reviewed-by: Jagan Teki <jagan@amarulasolutions.com>
32 lines
860 B
Text
32 lines
860 B
Text
CONFIG_ARM=y
|
|
CONFIG_ARCH_SUNXI=y
|
|
CONFIG_SPL=y
|
|
CONFIG_MACH_SUN8I_A83T=y
|
|
CONFIG_DRAM_TYPE=7
|
|
CONFIG_DRAM_CLK=480
|
|
CONFIG_DRAM_ZQ=15355
|
|
CONFIG_DRAM_ODT_EN=y
|
|
CONFIG_MMC_SUNXI_SLOT_EXTRA=2
|
|
CONFIG_INITIAL_USB_SCAN_DELAY=500
|
|
CONFIG_USB0_VBUS_PIN="AXP0-VBUS-ENABLE"
|
|
CONFIG_USB0_VBUS_DET="AXP0-VBUS-DETECT"
|
|
CONFIG_USB0_ID_DET="PH11"
|
|
CONFIG_USB1_VBUS_PIN="PD24"
|
|
CONFIG_AXP_GPIO=y
|
|
CONFIG_SATAPWR="PD25"
|
|
CONFIG_NR_DRAM_BANKS=1
|
|
# CONFIG_SYS_MALLOC_CLEAR_ON_INIT is not set
|
|
CONFIG_CONSOLE_MUX=y
|
|
# CONFIG_CMD_FLASH is not set
|
|
# CONFIG_SPL_DOS_PARTITION is not set
|
|
# CONFIG_SPL_EFI_PARTITION is not set
|
|
CONFIG_DEFAULT_DEVICE_TREE="sun8i-a83t-bananapi-m3"
|
|
CONFIG_PHY_REALTEK=y
|
|
CONFIG_SUN8I_EMAC=y
|
|
CONFIG_AXP_DCDC5_VOLT=1200
|
|
CONFIG_AXP_DLDO3_VOLT=3300
|
|
CONFIG_AXP_SW_ON=y
|
|
CONFIG_USB_EHCI_HCD=y
|
|
CONFIG_USB_OHCI_HCD=y
|
|
CONFIG_USB_MUSB_HOST=y
|
|
CONFIG_SYS_USB_EVENT_POLL_VIA_INT_QUEUE=y
|