Since we're using the kernel's module, this is
un-necessary.
Should speed up the build a bit.
Signed-off-by: Alexandru Ardelean <ardeleanalex@gmail.com>
Admittedly I never used those Python libs.
And the setup I was trying it on, did not have
the Python interpreter packaged, so these build failures
went un-noticed.
That's my fault for not trying it out properly on
a full LEDE repo, with all packages.
Signed-off-by: Alexandru Ardelean <ardeleanalex@gmail.com>
Add UCI section general which holds the uci parameter network defining on
which interface(s) the snmp agent is reachable for inbound snmp requests
in case the firewall zone does not allow INPUT traffic by default.
For the different zones to which the different interfaces belong firewall
procd input rules are created making the snmp agent reachable on udp port
161.
Signed-off-by: Hans Dedecker <dedeckeh@gmail.com>
Base LEDE/OpenWrt UCI for dnsmasq provides for DNS override in
/etc/config/dhcp. It is desired to be able to use dnsmasq and
Unbound as transparently as possible. Option 'add_extra_dns'
will pull 'domain', 'mxhost', 'srvhost, and 'cname' from base.
netifd/procd have an interaction with DHCPv6/RA on WAN (FS#713).
Minor IP6 parameter updates can cause Unbound reload events every
few minutes. List option 'trigger' selects which interfaces may
cause reload. For example 'lan', 'wan' but not 'wan6'.
Squash other cosmetics.
Signed-off-by: Eric Luehrsen <ericluehrsen@hotmail.com>
Below are changes in the packaging method
- Use tarball provided by the upstream project maintainer instead of
cloning the whole git-repo
- Drop openssl variant as it was deprecated then removed by the
upstream project
- Add dependency on libev, libsodium, libudns as they are not bundled
with the source code anymore
Addresses issue #4191
Signed-off-by: Yousong Zhou <yszhou4tech@gmail.com>
Convert init-script to procd and allow to configure
isc-dhcp-server via UCI. Allow most by-network and by-host options
supported by dnsmasq.
User-defined dhcp-options are not supported yet, neither are tags.
Existing configurations with use-edited /etc/dhcpd.conf are still
respected, hence to enjoy the new features you have to migrate
your configuration to UCI and delete /etc/dhcpd.conf.
Signed-off-by: Daniel Golle <daniel@makrotopia.org>
This is in essence fixes pip3.
That means pip3 will ship without Python byte-codes
for a while, until I'll find a better way to fix it.
I couldn't think of a not-very hack-ish way of doing it.
The only draw-back of this, will be that pip3 will run
a bit slower ; but that should be ok for a while.
Signed-off-by: Alexandru Ardelean <ardeleanalex@gmail.com>
