Those are L2 options that are not part of interfaces (L3), should not be
set there and don't work. Setting MAC and MTU should be done at device
layer (config device) and is supported for basic types already.
Signed-off-by: Rafał Miłecki <rafal@milecki.pl>
The introduction of network device configuration support also implemented
all common, protocol-independent interface options directly in the
interface config view, so drop the redundant option definitions.
Signed-off-by: Jo-Philipp Wich <jo@mein.io>
legacymap causes map to use the legacy IPv6 Interface Identifier format
that was described in draft-ietf-softwire-map-00, but was eventually
changed in RFC7597. It is however still used by some major ISPs,
including in Japan.
Signed-off-by: Remi NGUYEN VAN <remi.nguyenvan+openwrt@gmail.com>
"type" is already used as a common option for all protocols. This makes
the configuration ambiguous, and Luci sees JS errors when trying to save
a MAP configuration.
Switch to "maptype" instead to avoid the conflict. MAP currently uses
"maptype" and falls back to "type" when not specified.
Signed-off-by: Remi NGUYEN VAN <remi.nguyenvan+openwrt@gmail.com>
