I'm running several GRE tunnels to different locations and
the option to see and to configure GRE tunnels in LuCI was not
crucial but nice to have.
Signed-off-by: Jan Bětík <jan.betik@svine.su>
This addresses the issue of openconnect.sh from openconnect package expecting
a vpn- suffix for the files, while the frontend didn't.
Signed-off-by: Friendly fellow <DasTestament@users.noreply.github.com>
[reword commit message]
Ref: https://github.com/openwrt/packages/issues/11584
Signed-off-by: Jo-Philipp Wich <jo@mein.io>
This change allows to configure `nohostroute` option for wireguard to explicitely prevent creation
of host routes to endpoints.
By default without `option nohostroute '1'`, an explicite route to the peer's endpoint will be created in the main routing table with the next hop to the gateway. However, it causes issues with some setup. Enabling this option will inhibit this behavior. See discussions at http://lists.openwrt.org/pipermail/openwrt-devel/2019-March/016329.html.
Signed-off-by: Yuxiang Zhu <vfreex@gmail.com>
The proto handler qmi does support the delay option for modem
initialization. Add that missing option to the advanced tab to configure
that with LuCI.
Signed-off-by: Florian Eckert <fe@dev.tdt.de>
The option maxwait is not support by the 3g netifd proto.
To standardize that rename the maxwait option to delay as in the other
proto handlers luci-proto-qmi and luci-proto-ncm.
Signed-off-by: Florian Eckert <fe@dev.tdt.de>
Sometimes people only want the VPN connection to be a route to a specific
network, not the default gateway for all traffic.
I've tested this on my router and works fine!
Submitted-by: Whitronic <joao.f.vieira@gmail.com>
[reword commit message]
Signed-off-by: Jo-Philipp Wich <jo@mein.io>
Disabling LCP echos by *not* setting "option keepalive" was broken in
OpenWrt since https://dev.archive.openwrt.org/ticket/2373.html so setting
"0" in LuCI had the effect of reverting back to "5, 1" while the help
suggested otherwise.
Support for "keepalive 0" was fixed with https://git.openwrt.org/555c59230
so align LuCI now to emit "option keepalive 0" instead of removing the
option when entering "0" in the gui.
Fixes#2112
Signed-off-by: Jo-Philipp Wich <jo@mein.io>
Some modems are controlled only through a tty.
Autodetection of control device is broken in ncm.sh
Signed-off-by: Dmitry Tunin <hanipouspilot@gmail.com>
Due to historical reasons, the relayd daemon configuration resides in the
form of a fake "config interface" section in /etc/config/network without
actually registering a protocol handler.
This causes netifd to emit an "INVALID_PROTO" error for the interface
which is technically correct, but confusing for LuCI users.
This situation needs to be resolved upstream by either moving relayd
configuration out of the network config, or by converting the relayd
service into a proper protocol handler.
Until this happens, do not report any netifd errors since we're not
operating on an actual interface.
While we're at it, also propagate the protocol up state from the fake
virtual device to ensure that LuCI displays the relay bridge as "up"
when all relayed interfaces are up as well.
Signed-off-by: Jo-Philipp Wich <jo@mein.io>
