The underlying operating system for DifuseHQ's embedded routing devices
e8787291b3
Buffalo WSR-2533DHPL is a 2.4/5 GHz band 11ac router, based on MediaTek MT7621A. Specification: - SoC : MediaTek MT7621A - RAM : DDR3 128 MiB - Flash : SPI-NOR 16 MiB - WLAN : 2.4/5 GHz 4T4R (2x MediaTek MT7615N) - Ethernet : 10/100/1000 Mbps - Switch : MediaTek MT7530 (SoC) - LED/keys : 8x/6x (3x buttons, 2x slide-switches) - UART : through-hole on PCB - J4: 3.3V, GND, TX, RX from triangle-mark - 57600n8 - Power : 12VDC 1.5A Flash instruction using initramfs image: 1. prepare the TFTP server with the initramfs image renamed to "linux.trx-recovery" and IP address "192.168.11.2" 2. press the "AOSS" button while powering on the WSR-2533DHPL 3. after 10 seconds, release the "AOSS" button, WSR-2533DHPL downloads the initramfs image and boot with it automatically 4. on the initramfs image, download the sysupgrade image to the device and perform sysupgrade with it 5. wait ~120 seconds to complete flashing Switch position overview: - slide-switch1 (2x positions) - "AUTO" - "MANUAL" (not connected to gpio) - slide-switch2 (3x positions) - "ROUTER" - "AP" (not connected to gpio) - "WB" Signed-off-by: INAGAKI Hiroshi <musashino.open@gmail.com> [add note on switches, fix group->groups for state_default] Signed-off-by: Adrian Schmutzler <freifunk@adrianschmutzler.de> |
||
|---|---|---|
| .github | ||
| config | ||
| include | ||
| package | ||
| scripts | ||
| target | ||
| toolchain | ||
| tools | ||
| .gitattributes | ||
| .gitignore | ||
| BSDmakefile | ||
| Config.in | ||
| feeds.conf.default | ||
| LICENSE | ||
| Makefile | ||
| README | ||
| rules.mk | ||
_______ ________ __
| |.-----.-----.-----.| | | |.----.| |_
| - || _ | -__| || | | || _|| _|
|_______|| __|_____|__|__||________||__| |____|
|__| W I R E L E S S F R E E D O M
-----------------------------------------------------
This is the buildsystem for the OpenWrt Linux distribution.
To build your own firmware you need a Linux, BSD or MacOSX system (case
sensitive filesystem required). Cygwin is unsupported because of the lack
of a case sensitive file system.
You need gcc, binutils, bzip2, flex, python3.5+, perl, make, find, grep, diff,
unzip, gawk, getopt, subversion, libz-dev and libc headers installed.
1. Run "./scripts/feeds update -a" to obtain all the latest package definitions
defined in feeds.conf / feeds.conf.default
2. Run "./scripts/feeds install -a" to install symlinks for all obtained
packages into package/feeds/
3. Run "make menuconfig" to select your preferred configuration for the
toolchain, target system & firmware packages.
4. Run "make" to build your firmware. This will download all sources, build
the cross-compile toolchain and then cross-compile the Linux kernel & all
chosen applications for your target system.
Sunshine!
Your OpenWrt Community
http://www.openwrt.org