Difuse/difos
2
0
Fork 0
Code Issues Pull requests Projects Releases Packages Wiki Activity Actions
difos/target/linux/ath79
History
INAGAKI Hiroshi 643fcfc8d6 ath79: add support for NEC Aterm WG1200CR 
NEC Aterm WG1200CR is a 2.4/5 GHz band 11ac router,
based on Qualcomm Atheros QCA9563.

Specification:

- SoC		: Qualcomm Atheros QCA9563
- RAM		: DDR2 128 MiB
- Flash		: SPI-NOR 8 MiB
- WLAN		: 2.4/5 GHz 2T2R
  - 2.4 GHz	: QCA9563 (SoC)
  - 5 GHz	: QCA9888
- Ethernet	: 2x 10/100/1000 Mbps
  - Switch	: QCA8334
- LEDs/Input	: 12x/4x (2x buttons, 1x slide-switch)
- UART		: through-hole on PCB
  - JP1: Vcc, GND, NC, TX, RX from power connector side
  - 115200 bps

Flash instruction using factory image:

1. Boot WG1200CR normaly
2. Access to "http://192.168.10.1/" and open firmware update page
("ファームウェア更新")
3. Select the OpenWrt factory image and click update ("更新") button
to perform firmware update
4. Wait ~150 seconds to complete flashing

Known issues:

- cannot be controlled LEDs other than Power (Green/Red)
  - only Power LEDs are connected to SoC GPIO; other LEDs
    connected to the gpiochip on ath10k chip (QCA9888)

Signed-off-by: INAGAKI Hiroshi <musashino.open@gmail.com>
Signed-off-by: Christian Lamparter <chunkeey@gmail.com> [commit
message formatting]
2019-04-06 19:14:06 +02:00
..
base-files ath79: add support for NEC Aterm WG1200CR 2019-04-06 19:14:06 +02:00
dts ath79: add support for NEC Aterm WG1200CR 2019-04-06 19:14:06 +02:00
files ath79: ag71xx: remove switch driver in ag71xx 2019-03-24 01:44:27 +01:00
generic ath79: add support for jjPlus JA76PF2 2019-03-18 20:43:09 +01:00
image ath79: add support for NEC Aterm WG1200CR 2019-04-06 19:14:06 +02:00
nand treewide: use wpad-basic for not small flash targets 2018-10-16 15:07:41 +01:00
patches-4.14 kernel: bump 4.14 to 4.14.107 2019-03-22 18:14:28 +01:00
patches-4.19 ath79: add support for linux 4.19 2019-03-24 01:44:25 +01:00
tiny treewide: use wpad-basic for not small flash targets 2018-10-16 15:07:41 +01:00
config-4.14 ath79: add support for D-Link DIR-859 A1 2018-12-30 20:08:13 +01:00
config-4.19 ath79: add support for linux 4.19 2019-03-24 01:44:25 +01:00
Makefile ath79: Remove source-only flag 2018-11-26 12:24:54 +01:00
modules.mk ath79: add new OF only target for QCA MIPS silicon 2018-05-07 08:06:51 +02:00